Phone:
(08) 9240 1888
Mobile:
0400 203 662
Fax:
(08) 9240 1988

Guardian
Non Slip Stair Nosing Systems

Simple Installation

Installation Kit
Installation Kit for the Non Slip Stair Nosing System.

Guardian Non Slip Stair Nosing is easy to install. Manufactured in lengths of 5.8 metres it can be easily cut to fit any stair width. Then, it's a simple matter of Bond, Drill and Screw per the instructions shown below, with the installation kit shown to the right.

Professional Installation

We also have an Australia-wide network of distributors / installers who will provide a quick and professional response to your stair nosing requirements.

  • Clean stair edges with acetone

    1Clean stair edges with acetone.

  • Apply liquid nails to base of Stair Nosing

    2Apply liquid nails to base of Stair Nosing.

  • Firmly sit Stair Nosing onto stair edge

    3Firmly sit Stair Nosing onto stair edge.

  • Drill holes using masonary bit

    4Drill holes using masonary bit.

  • Gently tap in the fixing

    5Gently tap in the fixing.

  • Screw the fixing up tight

    6Screw the fixing up tight.

  • Clean top recess with acetone

    7Clean top recess with acetone.

  • Peel backing paper and place Non Slip insert into recess

    8Peel backing paper and place Non Slip insert into recess.

  • Cut excess Non Slip tape from end

    9Cut excess Non Slip tape from end.

  • Stairs are complete and ready for use

    10Stairs are complete and ready for use.